I created this design on 10 April 2021. It's a combination of a butterfly and a flower. So, you can use it the either way.
As the stem I used ordinary chenille stems. But chopsticks and wires will also work.
How to Fold the Butterfly Flower
Step 1
Prepare a square paper.
Step 2
Fold the paper in half.
Fold the other half, too.
Fold one side to the middle.
Fold the opposite side to the middle.
Turn the model over.
Fold the sides into the middle. But don't fold the outer edges.
Fold the model in half, as seen below.
Fold the bottom corners.
Fold the bottom corners inside. But don't forget the little flap.
Fold the inner flap inside as shown below.
Repeat on the other side.
Fold a corner like that.
Repeat three more times.
Fold a wing down following the lines.
Repeat for the other wing.
Fold one of the flaps inside to the side. You can leave it like that if you want a butterfly.
Fold the other flap inside, too. But you have to open the first one. And then repeat the steps.
Fold the inner corner back for a wing-like look.
Repeat three more times.
Fold the pointy parts inside to shape the wings.
Repeat three more times. You can shape the wings more. The butterfly flower is ready.
You can add a stem by wrapping around it or simply place in it.
Hiç yorum yok:
Yorum Gönder
Not: Yalnızca bu blogun üyesi yorum gönderebilir.